Page 2
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the
product for future reference.
BEFORE USE
You must inspect the product for any signs of damage. If the product is
damaged, DO NOT use it, and contact your supplier immediately.
INSTALLATION
Remove the mounting bracket from the loudspeaker, and, using it as a
template, mark the positions of the three fixing holes. Drill three holes, and fit a
wallplug in each hole. Attach the mounting bracket to the wall using
woodscrews and washers. Re-attach the loudspeaker to the bracket.
Connect the loudspeaker to a suitable amplifier.
The P111CD may be used with either 100 Volt line amplifiers or low
impedance amplifiers.
For use with a 100 V line amplifier:
Remove the rear cover of the P111CD and connect the output from the
amplifier to the terminals as follows:
There will be a two-core cable connected to the output of the amplifier.
Connect this cable to the loudspeaker as shown below:
Maximum power
Positive lead goes to:
Negative lead goes to:
50 W
Red terminal
Yellow terminal
25 W
Yellow terminal
Green terminal
12.5 W
Green terminal
White terminal
9 W
Red terminal
Green terminal
4.5 W
Yellow terminal
White terminal
3.5 W
Red terminal
White terminal
Choose the appropriate connection according to the volume required from
each particular loudspeaker. Use a higher power in noisy workshops, or a
lower power in quieter offices.
Do not connect more than two terminals.
Any number of loudspeakers may be connected to the amplifier, provided that
the maximum rated power of the amplifier is not exceeded. For each
loudspeaker connected, determine the maximum power (by looking at which
terminals are connected), and add up all these figures. The total must not
exceed the rated power of the amplifier.
Содержание P111CD
Страница 1: ...Page 1 P111CD Horn Loudspeaker...