Eagle 2000 B, Руководство по эксплуатации, Страница: 34 / 47

- 34 -
5.4 Turntable & Carriage Adjustment
Test Operation
Turntable
 Turn on the power
 From the Main Menu, press;
o
② Job Mode
o
② Manual Mode
o
①
Turntable (starts turntable rotation)
o
①
Turntable (stops turntable rotation)
 Verify there is no play in the turntable and that the fasteners are tight.
 The chain tension controls the amount of play in the turntable. The chain should have no more
than ±0.25" of play.
o
If greater than ±0.25" of play, tighten the chain using the chain adjustment screw located at
the back of the frame.
Fig. 5-1
Table Chain Adjustment
 Loosen the four holding screws of the turntable motor using a 6mm Allen Wrench.
 Turn the chain tension screw using an 8mm Allen Wrench.
o
Clockwise adjustment will tighten the chain and counter-clockwise will loosen the chain.
 After adjusting to an appropriate position, tighten the turntable motor holding screws.
Carriage Chain Adjustment
 Press ② Up to raise the carriage

Press
③
Down to lower the carriage
 Look and listen for smooth and consistent operation. If the action is not smooth, check the
carriage chain for obstructions, wear, or damage.