Eagle Eye Power Solutions, LLC
Keeping an Eye on Your Critical Power!
www.eepowersolutions.com | Tel: 1-877-805-3377 | Fax: 1-414-962-3660 | [email protected] | V1.0
Once lower range is set, press Z key to enter into the Upper limit range code 10. To set press S
key to adjust numerical value and Z key to change digit position. Press M key to save after
setting.
Code 11 will not need setting press M to save settings.
Restoring Factory Settings
Press and hold Z key for up to 3 seconds. Once you inter code 1 interface press Z key to shift
the flashing digit to the last space. Press S key to adjust numerical value to 5. You will enter
into the damping interface.
You will input code:
“05678” to restore all factory settings.
Press S key when upper arrow begins flashing. Press S key again to shift the flash point to the
first digit. Press Z to shift and input 6, repeat for 7 and 8 until screen shows
“05678”. Press S
key again and all decimals will start flashing. Pressing S key again will move the decimal point
past the 8. Once you have done this press M key to complete the factory reset.