The 3D printing process requires a supporting frame during printing, see below left. The
printed part is cut from the frame using flush cutters and this sometimes leaves small bumps on the
part. Use a knife with a sharp new blade to cut away the bumps. When trimming bumps off the
wheels you should place the wheel on a flat surface as shown below on the right. Putting too much
stress on the wheel can cause the axle to break. For bumps on the cab body, sanding is
recommended.
Page 2
www.eaelec.com
After cleaning up the bumps, paint the parts as shown on the painting guide on page 1. Once
these have dried, apply a coat of gloss to the cab, let dry and then place the decals as shown on
page 1. After the decals are completely dry, apply dullcoat to the cab.
When everything is dry assemble using CA glue, follow the steps below.
Final Assembly:
U.S.A.
4352931
U.S.A.
4352931
