EA3GCY EGV-9B BPFLPF, Быстрый старт

Страница: 8 / 12

EGV-9B_BPFLPF
module for EGV-9B CW Transceiver kit Page 8


L10 (18 turns) L11 (20 turns) L12 (18 turns)


PLUG IN MODULE - WIRING AND CONNECTIONS
 T
he EGV-9B_BPFLPF PCB is a plug-in module that sits on top of the EGV-9B's main board.
The connection is simple, but requires special attention so that errors do not arise.
1.- The three-
pin “V-TUNE” strip goes up and is soldered to the bottom side of the board.
2.- The other two strips of pins go down (to connect to the main board) and are
soldered to the top
side of the board.
Extra-long strips of pins are used. 8 extra-long pins strip for LPF switching and 6
extra-long pins strip for BPF switching.
Before soldering you should pay close attention to how tall the pins should be to accommodate the
position of the plug-in board.

Insert the pins from above the board (Top)

Next put the board in place no solder the pins.

Insert the pins into the female sockets of the main board all the way down.

With a fine soldering iron tip,
solder the pins on the top of the board.

Although it is not necessary, you can later tear off the plastic strip