e2v argus, Инструкция по эксплуатации и техническому обслуживанию

Страница: 19 / 25


e2v technologies (uk) limited 2013 CR 113590 P7250UM version 4, page 19
5. CLEANING, MAINTENANCE AND REPLACEABLE PARTS
•
Cleaning
After use and prior to stowing, the camera should be cleaned. This is best
carried out using a cloth soaked with warm soapy water.
Solvents should not
be used. If in doubt, contact your supplier.
•
Maintenance
No routine maintenance is required for the camera. If it is not in regular use, it
should be switched on for a period of ten minutes every month to check correct
operation.
•
Replaceable Parts
Due to the environment in which the camera is used, the user can replace
certain parts. If any damage beyond these parts occurs, return the camera to
e2v technologies or an authorised repair centre.
Any attempt at repair by unauthorised personnel may cause serious damage
and will invalidate the warranty.
THERE ARE NO OTHER USER
SERVICEABLE PARTS.
Handle (P7250HA)
To remove the handle, spin the large thumbwheel anti-clockwise until the handle
detaches from the camera body. Refitting is the reverse of the above, making
sure that the locating pip is positioned correctly.
Side Straps (P7030SS)
To replace the side straps, remove the front and rear bumpers. Unbuckle the
straps and pull through the retaining pins. Replacement is the reverse of
removal.
Front Bumper (P7030FB), Rear Bumper (P7030RB)
To replace the front and rear bumpers, unclip the bumper from the groove in the
case body and peel off. Replacement is the reverse of removal, making sure
that the bumper fits into the groove.
Other Spares and Accessories
Accessory Part Number
Neck Strap P7030NS
Rechargeable Battery Pack P7250R
Battery Charger Unit P7030BC
Battery Charging Shoe P7250CS
USB Computer Lead P7030PC
Bung P7030BU
User Manual P7250UM
CD-ROM P7250CD
Camera Carry Case P7250SC
Hard Carry Case P7030HC