E2S DL105H AlertAlight, Инструкция по эксплуатации/Сервисное руководство

Страница: 4 / 12

E2S Warning Signals Impress House, Mansell Road, Acton, London W3 7QH sales@e2s.com e2s.com D218-00-351-IS Issue 1 10/05/2021
S1 - LED Flash Mode Settings (AC & DC)
The Flash Mode Dip Switch can be changed to set the desired
flash pattern
Flash Mode DIP Switch – Shown with 1-OFF, 2-ON, 3-OFF (0 1 0),
This denotes Flash mode 1Hz. For further flash modes refer to
table:
Switch
Flash Mode
0 0 0 Steady on
1 0 0 Blinking
0 1 0
Flashing 1Hz *
1 1 0
Flashing 1.5Hz *
0 0 1
Flashing - Double Strike
1 0 1
Flashing - Triple Strike
0 1 1
Flashing 2Hz *
1 1 1
Flashing - Temporal
1 2 3
ON
•
All models are approved for use as Audible Signal and Visual Appliance
for use as General Signaling: UL464A & CSA C22.2 No 205-17
•
Type 4 / 4X / 3R / 13, IP66
•
-
40°C to +66°C / -40°C to +151°F
General Signaling Canada:
DL105HDC: -40°C to +55°C / -40°F to +131°F
DL105HAC: -40°C to +40°C / -40°F to +104°F
•
To maintain Ingress Protection, cable entries must be fitted with suitably rated cable glands or stopping plugs
• Mounting - Units can be mounted using the 2-off 10 x 7mm obround holes in the mounting lugs.
•
EOL Monitoring (DC Only): End of Line Devices may be fitted between the +ve & -ve terminals of the PCBA. Please ensure that the device
legs meet the wire size range stated for the connection terminals and are fitted correctly in order to avoid a short. Refer to the compatible
control panel specification for EOL device values and ratings
Model
Nominal
Voltage
Voltage Range
Nominal Operating Current* Max Operating RMS
#
Beacon Sounder Beacon Sounder
DL105HDC024
12V dc 10-14Vdc 79.5mA 17mA 168mA
125mA 24V dc 16-33Vdc 87mA 33.5mA 183mA
DL105HDC048 48V dc 48-60Vdc 60mA 113mA 115mA
DL105HAC230
115V ac
48 - 260Vac
50/60Hz
34mA 25mA
42.5mA 166mA
230V ac 19mA 17mA
*Nominal Voltage, 1Hz Flash Pattern & Tone 12;
#
Worst-case input voltage and worst case flash pattern
Attention: Installation must be carried out by an electrician in compliance with the National Electrical Code, NFPA 70 or CSA 22.1 Canadian Electrical
Code, Part I, Safety Standard for Electrical Installations, Section 32. / L'installation doit exclusivement être réalisée par du personnel qualifié, conformé
ment au code national d'électricité américain, NFPA 70 ou CSA 22.1 Code canadien de l'électricité, première partie, norme de sécurité relative aux
installations électriques, Section 32