European Safety Systems Ltd.
Impress House, Mansell Road, Acton, London W3 7QH
www.e2s.com
Tel: +44 (0)208 743 8880
Document No. D210-00-611-IS
Issue 9
12-09-2022
Sheet 6 of 7
14
Settings
14.1 Tone Settings
The sounders have 32 different tones that can be selected for
the first stage alarm. The sounders can then be switched to
sound second and third stage alarm tones. The tones are
selected by operation of a DIP switch on the pcb for both DC
and AC units. The tone table D210-95-001-IS shows the switch
positions for the 32 tones and which tones are available for the
second and third stages. To operate the sounder on stage one
simply connect the supply voltage to the normal supply
terminals (+ve and –ve for DC units, L and N for AC units).
Refer to wiring schematics D210-06-601 (DC) or D210-06-605
(AC).
Default =
Tone 1
0 0 0 0 0 0
(ON = 1, OFF = 0)
Figure 8: DIP switch configuration
14.2 Volume Control
The output level of the BEx sounder can be set by adjusting
the volume control potentiometer (see Fig 9). For maximum
output, set the potentiometer fully clockwise.
BExCS110-L2D-P AC
BExCS110-L2D-P DC
Fig.9 Location of Volume Control Potentiometer
14.3 Flash Rate Settings
The BExCS110L2D beacons can produce different flash
patterns as shown in Table 1. The flash patterns are selected
by operation of the flash setting DIP switch on the PCB, Fig
10.
Table 1: Switch Positions for Flash Patterns
Fig. 10: DIP Switch Location
Switch
Setting
S1 Mode
S2 Mode
S3 Mode
(123456)
(DC & AC)
(DC Only)
(DC Only)
000000
Steady High
Power
Flashing 1Hz
Flashing Triple
Strike
000001
Steady Low
Power
Flashing 1Hz
Flashing Triple
Strike
100000
Flashing 1Hz
Flashing
Double Strike
Flashing Triple
Strike
101000
Flashing
1.5Hz
Flashing 2Hz
Flashing
Double Strike
010000
Flashing 2Hz
Flashing Triple
Strike
Flashing Triple
Strike
110000
Flashing
Double Strike
Steady High
Power
Flashing Triple
Strike
001000
Flashing
Triple Strike
Flashing 2Hz
Flashing
Double Strike
Warning - High noise levels above 85dB(A)
during operation. High levels of noise may
cause hearing loss, wear suitable ear
protection when equipment is in operation.
Warning – high-intensity light source.
Avoid looking directly at the light source
for extended periods of time.
Volume Control
Potentiometer
Volume Control
Potentiometer
Содержание BExCS110-L2D-P Series
Страница 9: ...Page left Intentionally blank...
Страница 16: ...Page left Intentionally blank...