E-Z-GO Terrain 1500, Руководство пользователя

Страница: 60 / 78

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
5 - 14
5
If vehicle is to be stored over winter months, it can be stored with old oil left in engine. The oil should be changed as
part of spring maintenance. This will remove any moisture that has accumulated during storage.
STARTER/GENERATOR BELT TENSION
Tool List Qty.
Belt tension gauge .................................................................................................................................................. 1
Wrench, 3/4" ........................................................................................................................................................... 1
Wrench, 9/16" ......................................................................................................................................................... 2
Ratchet, 3/8" drive .................................................................................................................................................. 1
Socket, 3/4", 3/8" drive ........................................................................................................................................... 1
The starter/generator belt tension should be checked after the first 15 - 20 hours and set to 75 - 80 lbs. (34 - 36 kg)
A loose belt can cause audible vibration and squeal.
Tighten a new starter/generator belt to 115 - 125 lbs. (52 - 57 kg) tension when a gauge is applied half way between
the two pulleys.
A new belt may be checked manually. A maximum deflection of 3/8" (10 mm) is acceptable. Tighten an existing belt
to 75 - 80 lbs. (34 - 36 kg) tension using the same technique and inspect for cracking or wear. A maximum deflection
of 1/2" (13 mm) is acceptable.
Adjusting The Belt
Loosen the starter/generator pivot bolt. While holding the lower adjusting nut with a wrench, loosen the upper jam nut
with another wrench. Move the lower nut up or down the adjustment bolt until proper belt tension is achieved. Hold
the lower nut in place and tighten the upper jam nut against it.
NOTICE
NOTICE
3/8" (1 cm) Maximum
Deflection (New Belt)
1/2" (1.3 cm) Maximum
Deflection (Existing Belt)