Assemble your structure:
Below is a diagram of an assembled structure. Your structure should look like this once assembled.
Note: When assembling your structure make sure you put a screw in each hole in each bracket to make sure your
structure is rigid and solid when completed.
Step 4:
Lay out your base first using your 90 degree brackets. Make sure (VERY IMPORTANT) that you face the
brackets the way they are shown in the diagrams above. Failure to do this may make some measurements off later in
assembly and the structure not go together properly. Layout your brackets and lumber for your base per the floor
plan diagram below. Only put a single screw in piece of lumber on the door side of the building as you may have to
adjust the studs to make sure the door fits correctly depending on the size hinges you will be using.
Step 5:
Next assemble your roof trusses. It is typically easier to assemble them on the ground and then put them in
to place on the stud walls. Make sure you use a level for the bottom of the truss (letter B) so they are level or
