E-TRAK/R 5000, Руководство пользователя

Страница: 11 / 30

14
Do not unlock battery or PDA
will fail to operate.
OPERATION
Control Head
The E-TRAK/R-5000 uses a PDA Control Head featuring E-TRAK/R
Software, which communicates with the E-TRAK/R-5000 via Wireless
RF signals or by the PDA Interface Cable wired link. Tracker frequency
settings, Tracking modes, Control Head behavior, and Beacon controls are
managed by the software operating in the Control Head.
ON / OFF/ DIM Switch
This switch toggles the PDA ON and OFF. Hold the button down for several
seconds to dim the display. There is also a soft switch to dim the display
included in the display window. Use one or the other to dim display, not both.
Software Controls
All of the E-TRAK/R capabilities are available through the touch screen
soft controls. Use the stylus provided to make selections on the display
screen. DO NOT attempt to install other software into the PDA Control
Head.
The PDA should be RESET occasionally (switch on bottom of PDA) to take
advantage of the memory management program within. After 60 hours of
continual operation you may get a warning to restart the PDA if memory
becomes low.
To switch communication modes (cabled/wireless) for your PDA Control
Head:
Turn the PDA Control Head ON
Select communication icon from the lower right of display screen
Select mode (cabled or wireless) from the pop up menu
Connect/disconnect the communications cable for your desired mode
Turn the E-TRAK/R ON.
NOTE: E-TRAK/R and PDA should always be rebooted when changing
modes of communication. For a “clean” reboot wait 10 seconds with
power off, then turn on again.
Top Edge of PDA Control Head
ON/OFF (momentary switch)
and DIM (hold) button.
Bottom Edge of PDA Control Head
Use stylus and press reset switch if
Control Head becomes “hung”. Reboot both the
PDA and E-TRAK/R.
Control Head with PDA Interface Cable
and Protective Case