Remove the battery cover from the rear of the Remote Control and place 2xAAA size batteries inside the compartment.
Please make sure the battery polarities match the polarity markings inside the compartment.
To use the Remote Control, point it towards the front of the Digital Set Top Box. The Remote Control has a
range of up to 5-6 meters from the Set Top Box at an angle of up to 60 degrees.
Installing the Batteries
using the Remote Control
For a basic connection from your Set Top Box to the television, use the SCART connection.
For the highest quality connection use a direct HDMI connection, see picture
Connecting to a television
After all connections have been made properly, switch on Tv and make sure the unit is connected
to the Main Power. Press Power button to switch the unit on. If you are using the unit for the first
time or have restored the unit to factory default, the installation guide menu will appear on your Tv
screen. Select Antenna Power ‘On’ if you’re using Active Antenna.
(1) [OSD Language] press RIGHT/LEFT key to select a language.
(2) [Province/Area] press RIGHT/LEFT key to select your province/area of residence.
(3) [Antenna Power] press RIGHT/LEFT key to select antenna power on or off.
(4) [Channel No.] press RIGHT/LEFT key to select a channel. For selecting the channel, please find
out on which channel the Digital Tv signal is transmitted in your living Area.
(5) Make sure the signal ‘quality bar’ and the “signal strength bar” is more than 70% and up.
Press ‘OK’ to start to do channel searching.
(6) Once channel tuning is complete, you can start watching Tv programs.
First time Installation
The manufacturer reserves the right to change the configuration, technical or any other parameters without prior notice.
troubleshooting
Problem
Potential Reasons
What to do
No picture
Power isn’t connected
Connect the power
The power switch is not on
Switch on the power
Screen shows’ No Signal’
Areal cable not connected
Plug in the Areal cable
Aerial cable is faulty
Check aerial cable and connections
No sound from speaker
No or incorrect connection with
SCART /HDMI cables
Connect the cables correctly
The program is a radio program
Press <Tv/Radio> key to shift into Tv mode
Remote Control is not responding
The battery is exhausted
Change battery
Remote Control is not facing or close enough to the STB Adjust the position of the Remote Control and move
closer to the unit
Picture is breaking up
The signal is too weak
Check aerial, cable and connections, use signal quality /
strength meter as described above
