11
OPERATION
General Operation
Protocol/Baud rate Selection
Function Procedure
LED
LED shows the power on, shift lock or Tx/Rx status.
Enter
Press ENT to select a number that has been entered. In Menu Mode, goes to previous
menu with saving.
Clear
Press ESC to cancel a number that has been entered. In Menu Mode, goes to previous
menu without saving.
Control
If you move the joystick with CTRL key pressed, the slowest speed of pan, tilt or zoom
is applied.
Shift
Press SHIFT to allow the numeric keyboard to send left, right, up or down commands.
If you move the joystick with this key pressed, the fastest speed of pan, tilt or zoom is
applied.
Select Camera
LCD display shows camera number in CAMERA mode.
Enter camera number and press CAM to select.
Select DVR
Enter DVR number and press DVR to select.
Select Monitor
Enter monitor number and press MON to select.
Pan/Tilt/Zoom
Move the joystick until the camera reaches the desired position. To increase
the speed of movement, move the joystick further from center. Twist the joystick
clockwise to zoom in(tele), counterclockwise to zoom out(wide).
Enter a CAMERA address (1-999) and the press
SETUP
key.Use numeric keys or joystick to select a protocol
and/or baud rate.
TURBO speed: Move the joystick with SHIFT key pressed.
Slowest speed: Move the joystick with CTRL key pressed.
Lens Control
(focus/iris)
Focus, iris - Press and hold the appropriate lens control key until the desired effect is
seen.
Presets
Program
Position camera and then enter desired preset number (1-240) and hold down PRST for
two seconds.
Call
Enter preset number (1-240) and press PRST to put camera in preset position.
Clear
Enter desired preset number (1-240) and press PRST with CTRL key pressed.
Patterns
Program
Enter a pattern number (1-8) and hold down
PTRN
for two seconds. The monitor will
indicate the programming function is active. Move the camera position as desired for the
pattern.
To save and exit the programming function, hold down PTRN for two seconds.
Call (Run)
Enter a pattern number and press PTRN. Move the joystick or call a preset to stop.