If you wish to remove the battery from the bike for charging, first
remove the foot mat. Unlock the battery locking strut with the ignition
key and lift up the case. Remove the internal plug from the underside
of the battery. After charging, replace the battery in the bike making
sure you plug it in once again and lock the battery in place.
Please
DO NOT use any other charger
than the one supplied with
your bike. Also do not modify the bike in any way or replace any parts
from other suppliers. We cannot accept responsibility for damage or
failure caused by products which are not specifically made for use with
the
E
RIDER
.
Operation:
When you are ready to ride your
E
RIDER
,
check first that the
motor is unlocked.
Go to the left side of the rear wheel and locate
the blue motor lock. Using the key with the red button make sure that
the motor is unlocked. The rear wheel will not turn when the motor is
locked. If you are doing this in the dark, pressing the red button
provides a small light to assist in inserting the key.
Now you should sit on the bike to adjust your mirrors and check that
you can see behind you from your riding position.
The bike can now be started using either the ignition key or the
remote control.
To switch on the bike with the key, locate the power key socket below
and to the right of the handlebars. Select the ignition key. Insert the
key and turn to the 'ON' position. The information display will light up
and you are ready to go. The throttle is operated by the right handle
on the handlebar.
To start your
E
RIDER
without inserting the key, press the start key
button on your remote twice. You will see the panel light up and you
are ready to go by turning the throttle on the right handlebar handle
as above.
