9
Setting of Clock and Alarm Times
(Instructions are also available on the key tag)
AM/PM or 24-Hour Time (military time) Formats
Your e-pill MedTime SAFE automatic pill dispenser automatically defaults to a 24-
hour time format.
To switch to a 12-hour format, press buttons 2 and 3 simultaneously.
The
AM
or
PM
symbol will appear on the right side of the display when the clock is in
the 12-hour time format. Release the buttons when the desired time format is displayed.
CLOCK - Setting the Clock (current time)
1.
Press and Hold button 1 for a few seconds (until the symbol
“:”
blinks located
between Hours and Minutes) and then release.
2.
Set the correct time by pressing buttons 2 (Hours) and 3 (Minutes).
3.
Store clock time by Pressing Button 1 and symbol
“:”
stops blinking.
If buttons 2 or 3 are held/depressed, the time display progresses automatically. If one lets
the display continue to blink in the setting mode it will automatically return to normal
function after approximately one minute. AM and PM indicators is located on the right
side.
ALARMS - Setting and Checking the Alarm Times
*
The numbers of alarms you have programmed are visible on the left side of the display.
1.
Press button 1 and then release. The
Alarm 1
symbol will begin to blink. To set alarm
time # 1; press Button 2 (Hours) and Button 3 (Minutes). If you wish to cancel the
alarm, press button 2 until
--: --
is displayed, which occurs after
23:00
or
11:00
p.m.
2.
After you have programmed the correct alarm time, press button 1 again to store the
alarm time and to advance to the next Alarm setting.
To set alarms 2, 3, 4, 5 & 6 follow the same steps above.
3.
End by pressing and holding Button 1
(once all alarms have been set)
.
