background image

HOW TO SET DAILY ALARMS

While in normal time mode, Tap button C (ALARM) to go 
to the alarm you want to set  (AL-1 up to AL-8).

Press & hold button D (SET) for 3 seconds to enter 
setting mode.  The 

Hours

 will start flashing.

Tap A (+) or B (-) until the correct 

Hour

 is reached. 

Please note the 

AM/PM

 indicator above in the top left 

hand corner. 
Tap D to move on to 

Minutes

. Tap A (+) or B (-) until 

the correct 

Minute

 is reached.

Tap D to leave setting mode.

Tap A to select alarm mode for each alarm. The possible 
settings are:

Sound Alarm On
Vibrating Alarm On
Both Sound and Vibration Alarm On 
Alarm OFF (no symbol shown)




To proceed to your next alarm, tap C (ALARM). 

The  alarm  will  vibrate,  sound  or  both  for  20  seconds, 
followed  by  40  seconds  of  snooze.  This  sequence  will 
repeat two (2) times. 

TO STOP THE SNOOZE, TAP ANY BUTTON 

NO  Alarm  reset  required- 

Regardless  of  what  you  do, 

alarms  will  reset  at  midnight  and  automatically  repeat 
every day at the same time.

WHEN AN ALARM GOES OFF

POWER SAVING FUNCTION

You may want to temporarily shutdown your e-pill HÄGER 
in order to save the battery (power saving mode). To do 
this,  press  all  four  buttons  A+B+C+D  at  the  same  time 
while in normal time display. While in power saving mode, 

the clock will stop

, the display will turn off, but the alarm 

settings will be remained.

To re-start your e-pill alarm watch, press and hold all four 
buttons A+B+C+D and then set your watch to the correct 
the Time and Date.  Your alarm settings are still retained.

BATTERY REPLACEMENT

Unscrew the watch bottom cover and open it.
Unscrew the battery holder.
Replace the battery with a new 3 Volt Lithium Button Cell 
(CR2032). The + side should be facing you.
Screw back the battery holder.
Use a metal tool to short circuit the two RESET contacts (see 
illustration below).
Check the watch display to make sure it is working. If not repeat 
these steps.
Screw back the bottom cover with the words at the bottom cover 
facing up.
Perform the alarm signal test to make sure vibrator and beeper works.
Battery life is estimated to be 4 to 6 months but depends on the 
number of alarms and how long each alarm is sounding.





Battery:

 CR2032 3V Button Cell

We suggest you take the watch to a jeweler to have the 
battery replaced to minimize the risk of mishandling the 
watch. I you do need to replace the battery yourself, follow 
these instructions:

HÄGER  covers  manufacturing  defects  for  one  year 
from date of purchase. Battery, straps, glass or damage 
caused by misuse are not covered. During the warranty 
period, and upon proof of purchase, your watch will be 
repaired or replaced at the manufacturer’s opion.

WARRANTY

Version 101020

Printed in China

This watch is designed to help the wearer to remember his/

her medication on time. The manufacturer HÄGER takes no 

responsibility whatsoever for any inconvenience or non-compliance 

to medications in the event the watch fails to function.

  This Operating Instruction is protected by copyright. 

©Copyright e-pill, LLC, 2010

 e-pill® and HÄGER® are trademarks owned by e-pill, LLC and Monico 

Properties Ltd.

WARNING

LIABILITY

e-pill, LLC (or your distributor)
49 Walnut Street, Bldg. 4
Wellesley, MA 02481
USA
www.epill.com

(781) 239-2941 or Toll-Free: 1-800-549-0095
(781) 235-3252

Contact:
Adress:

Web site:
Phone:
Fax:

RESET

Отзывы:

Похожие инструкции для HÄGER