INSTALLATION (A) - SIGNAL OVER POWERLINE
1. Make sure that all devices are switched off before starting the installation of the product.
2. Connect the HDMI output of your signal source to the transmitter (TX, input) of the HDT 300.
3. Additionally, you may connect a second TV or beamer to the transmitter (TX, loopout).
4. Connect the output of the receiver (RX, output) to the HDMI input of your TV or beamer.
5. Check the setting of the select button of transmitter and receiver both must be set to „Power Line“.
6. Connect transmitter and receiver each to the mains power inside of the same electric circuit, using the included power
cables. An additional phase coupler may be used at different phases at one counter circuit. Transmitter and receiver will
sync automatically.
7. Turn on all connected devices.
8. When not in use, remove transmitter and receiver from mains circuit!
INSTALLATION (B) - SIGNAL OVER LAN
1. Make sure that all devices are switched off before starting the installation of the product.
2. Connect the HDMI output of your signal source to the transmitter (TX, input) of the HDT 300.
3. Additionally, you may connect a second TV or beamer to the transmitter (TX, loopout).
4. Connect the output of the receiver (RX, output) to the HDMI input of your TV or beamer.
5. Check the setting of the select button of transmitter and receiver: both must be set to „Telephone Line“.
6. Connect transmitter and receiver each to a network port, using the included modular cables.
7. Connect transmitter and receiver to the mains power. It is not necessary to connect both at the same mains circuit while
data transfer over LAN. Transmitter and receiver will sync automatically.
8. Turn on all connected devices.
9. When not in use, remove transmitter and receiver from mains circuit!
To de-install the product, follow the above mentioned steps in reverse direction.
TRANSMITTER
RECEIVER
1) Reset button
2) HDMI input
3) HDMI output (loopout)
4) RJ11 modular port for LAN
5) select button Powerline/LAN
6) power connection (110 - 240V AC)
7) LED “HDMI“
- shining = HDMI source is connected
8) LED “signal“
- shining = searching a signal
- flashing = data transfer
9) LED “power“
- shining = connected to mains power
Loopout
Input
Telephone
Line
Switch
Power
Line
Reset
1
2
3
4 5
6
7 8 9
1) Reset button
2) HDMI output (loopout)
3) RJ11 modular port for LAN
4) select button Powerline/LAN
5) power connection (110 - 240V AC)
6) LED “signal strength“
- low level, try another power or network socket
- medium level, maybe transmission is not noisefree
- high level, transmission faultless
7) LED “HDMI“
- shining = HDMI reproducer is connected
8) LED “signal“
- shining = searching a signal
- flashing = data transfer
9) LED “power“
- shining = connected to mains power
Output
Telephone
Line
Switch
Power
Line
Reset
1
2
3 4
5
8 9
7
6
