Getting Around
3
NAVIGATION
Activating Modules and Selecting Functions
Each module has an associated switch. These are grouped on the left side of
the display. Pressing the associated switch activates the module and is indi-
cated by an LED next to the switch. Upon activation the top line of the
display will show the module identifier.
Once the module has been activated, the function keys below the display are
used to select the function located directly above it. You can think of the E4K
like a book— each time you press a function key, you are turning to another
page in the book. The module select keys are like chapters in the book.
When you're finished with a module, either press its button again to deacti-
vate, or simply activate a new module. Any time you make a mistake, get
confused or otherwise “get lost in the module”, you can bail out by simply
deactivating, then reactivating the module.
Main Screen
When all the module LEDs are off, you are in the main preset selection
screen (shown below). This screen can also be accessed by pressing the Exit
key repeatedly from wherever you are.
Function Keys
Module Select Keys
P R E S E T
S A M P L E
Hot Tip…
If you want to “Lock” the Sprint, Load, Save and Multi keys on the Main
screen instead of the arrow key, simply
press and hold the arrow key for
two seconds
. To hide the menu options again, press
Hide
.
Press and hold this key for two
seconds to display the menu bar
at the bottom of the display
instead of the arrow.
