EN
Re-set speed should be in accordance
with the local regulation speed. If exceed
your re-set figure, the bike will travel at
the max speed of reset. Default max
speed in factory is 25 Km/h.
Speed option: 12-40Km/h, use UP or
DOWN then confirm by MODE. Then
enter into the interface of backlight
brightness.
Backlight Brightness
The third setting parameter is backlight brightness. The interface is as below:
Press UP or DOWN to modify the backlight
brightness. You can choose from level 1 to
level 3. Level 1 is the minimum brightness.
Level 3 is the maximum brightness. The
default value of the backlight brightness
is level 1. Press the MODE to confirm the
backlight brightness, then entry into the
interface of Choice of Display Unit.
Choice of Display Unit (Metric system / British system)
The fourth setting parameter is Choice of Display Unit. The interface is as below:
Press UP or DOWN to choose a display
unit. The unit could be MPH or Km/H. The
range unit will change accordingly with the
speed unit.
Quit from set up
In the setting state, press MODE for 3
seconds to confirm the input, save current
setting and exit.
Standard Operation
ON / OFF
Press MODE, then the display starts to work and supply power to controller, long press
MODE then switch off power.
In the status of OFF, display and controller no longer consume battery power.
Capacity Display
When the battery capacity is high, the five battery segments are all light. When the battery
is in low voltage, the last battery segment will flash at 1 Hz. It indicates that the battery is
severely low in voltage condition and needs to be recharged immediately.
Speed Display (Current Speed/Average Speed/Max Speed)
When the e-bike starts, the display will automatically show the current speed.
Hold UP and the display will show the MAX speed during this ride. Hold UP again and the
display will show the AVG speed during
this ride. Hold UP again and the display
will turn to the current speed display.
The interface of switching
speeds
Assisted Power Select or Throttle Level
Select
Press UP or DOWN to change the output
power of the motor. The power ranges
from Level 1 to Level 5. Level 1 is the minimum power. Level 5 is the maximum power. The
default level is Level 1.
The choice of motor power rate
Distance Display (Riding Distance / Total Distance)
Press MODE to switch between riding distance and total distance. This function is conve-
nient for users to check the riding distance (TRIP) and the total distance (ODO).
Range Interface
Push Cruise Control
Press DOWN for a while to get into power assist mode, and the bike will travel at fixed
speed 6Km/h.
Interface of power assist walk
Warning: Push cruise control mode is recommended under push state, not for riding mode.
Turn On and Turn Off the Backlight
Hold both UP and MODE for 3 seconds and turn on the SW-LCD backlight, when the
surrounding light is not enough or it is in the evening. Hold both UP and MODE for 3
seconds again and you can turn off the SW-LCD backlight. When the backlight power ON,
the headlight also power on (if the bike assembles with a headlight). And the function could
be customized.
Power of the Display
Display the real time power consumption of the riding for electric bike. The interface below:
Error Code Display
If there is something wrong with the electronic control
system, the display will show the error code automatically.
The following is the definition of the error code.
Code number
Definition
21
Abnormal current
22
Throttle fault
23
Motor phase problem
24
Motor Hall defect
25
Brake Failed
30
Abnormal Communication
Содержание Kasanova
Страница 1: ......
