5 из 6
USER MANUAL
Made in a lab
E-Mode.pro
www.E-Mode.pro
Made in a lab
E-Mode.pro
www.E-Mode.pro
Setting humidity level
Humidity level of a substrate is its moistening degree.
Press
Ⓜ
button once to enter humidity setting mode. The led indicator
turns on blue.
With
←
and
→
buttons setup humidity level: 0 - 100%, when watering
mode should start operating.
Press
Ⓜ
button again to save the setting and turn to watering time setting.
Setting watering time
Watering time is a time period when the device supplies the
pump/electromagnetic valve with power.
Press
Ⓜ
button twice to enter watering time setting mode. The led
indicator turns on green.
Watering time is setup in seconds and minutes: 1 sec – 10 minutes.
With
←
and
→
buttons setup minutes and seconds of watering period.
Press
Ⓜ
button to save the setting and turn to watering intervals setting.
Setting watering intervals
Watering interval is a time period for the substrate to soak up nutrient
solution.
When this period is over the device take measurement of a current
humidity level to compare it with a setup data and if necessary starts
watering again.
Press
Ⓜ
button three times to enter watering interval setting mode. The
led indicator turns on red.
Watering interval is setup in minutes and hours: 1 minute – 10 hours.
With
←
and
→
buttons setup minutes and hours of watering intervals.
Settings by default
• Humidity level - 70%.
• Watering time - 30 sec.
• Watering interval - 1 hour.
The device waters during 30 seconds, if the humidity level is below 70%.
Watering is repeated in an hour, if the humidity level is below 70%.
