E-Mist EM360, Руководство пользователя, Страница: 11 / 16

BackPack User Guide | 7
Preparing the Spray Area
Make sure food and drinks are removed or covered before
spraying.
Spotless, clean interiors require no prep work prior to
spraying.
Loose debris must be swept from floors and other surfaces
prior to spraying.
Inspect the area for mechanical barriers such as: magazines
on table tops, chairs touching each other, a table or a wall.
The intended touch point for disinfecting will need to be
accessible.
Please cover and remove valuables. Electronics, furniture,
paper, or other common necessities do not need to be
removed from the area.
Once the area has been cleaned, disinfecting can begin.
Spray Application Process
1. Begin at the farthest point from the doorway, work
back toward the doorway so you can step out when
done.
2. Aim spray device 3 feet from the target area, begin
with a smooth figure “S” movement aiming below, at
and above the target area while walking at a slow pace
(3 ft. per second) continuously moving.
3. Make sure you are working in a methodical “S” pattern
and let your passes overlap when moving to the next
target area.
4. Allow the treated area to set for contact time as rec-
ommended by the disinfectant manufacturer’s label
before re-entry into the area.
Fluid Management
The BackPack System is designed for single or multiple
fluid application environments. Please use multiple tank
applications carefully by marking tanks with your chemical
identifiers if necessary. Application tips:
♦
While depressing trigger button, move wand in an “S”
pattern from bottom to top of target in a continuous
motion.
♦
Keep moving – electrostatically charged droplets will
accumulate at higher levels at the tip of the wand if you
move too slowly.
♦
Do not over apply. The tendency to “paint the fence” is
an over usage of chemicals.
♦
In between chemical changes, press trigger while
pointing to the floor or other safe target for four to five
seconds to clear the remaining chemical in the cable.
Battery Management
The BackPack System battery utilization is controlled to
draw down the battery to 20% of available cell power and
4
Spray Application
If the spray device becomes wet or begins to drip,
you are moving too slow over the target and need
to speed up the process. Do not over-saturate the
surface, if you see runs or puddles you are apply-
ing too much of the solution. The goal is to achieve
even coverage over the surface area.
NOTE: The BackPack System is NOT a Mechanical Cleaner