E-line ELI-ECO3-CVIM-4, Руководство пользователя

Страница: 144 / 185

187
Figure 5-50
Please refer to the following sheet for detailed information.
Parameter Function
Enable You need to check the box to enable motion detection function.
Please select a channel from the dropdown list.
Period Motion detection function becomes activated in the specified
periods. See Figure 5-48.
There are six periods in one day. Please draw a circle to enable
corresponding period.
Click OK button, system goes back to motion detection interface,
please click save button to exit.
Anti-dither
System only memorizes one event during the anti-dither period.
The value ranges from 5s to 600s.
Sensitivity
There are six levels. The sixth level has the highest sensitivity.
Region If you select motion detection type, you can click this button to set
motion detection zone. The interface is shown as in Figure 5-49.
Here you can set motion detection zone. There are four zones for
you to set. Please select a zone first and then left drag the mouse
to select a zone. The corresponding color zone displays different
detection zone. You can click Fn button to switch between the
arm mode and disarm mode. In arm mode, you can click the
direction buttons to move the green rectangle to set the motion
detection zone. After you completed the setup, please click
ENTER button to exit current setup. Do remember click save
button to save current setup. If you click ESC button to exit the
region setup interface system will not save your zone setup.
Record
channel
System auto activates motion detection channel(s) to record once
an alarm occurs. Please note you need to set motion detect
record period and go to Storage-> Schedule to set current
channel as schedule record.
Record Delay System can delay the record for specified time after alarm ended.
The value ranges from 10s to 300s.
Alarm out Enable alarm activation function. You need to select alarm output
port so that system can activate corresponding alarm device when
an alarm occurs.
Latch
System can delay the alarm output for specified time after an
alarm ended. The value ranges from 1s to 300s.