e-Line Technology Sibell NVR-SB64, Руководство пользователя

Страница: 87 / 108

Device Management
NVR User Manual
81
3
Set the NVR’s IP address, subnet mask and gateway and so on corresponding to the router.
4
Check “Enable” in the interface as shown below and then click “Apply” button.
Click “Refresh” button to refresh the UPnP status. If the UPnP status were still “Invalid UPnP”
after refreshing it for many times, the port number would be wrong, or UpnP is disabled in the
router. If UpnP is enabled, please change the mapping type to “Manual” and then click to
modify the port until the UPnP status turns to “Valid UPnP”. Refer to the following picture.
You can view the external IP address of the NVR. Input the external IP address plus port in the
IE address bar to access the NVR such as http://183.17.254.19:81.
11.1.6 NAT Configuration
Click Start

Settings

Network

NAT to go to the interface for NAT configuration. Check
“Enable” and then select the NAT server address (
nat.autonat.com by default). Click “Apply”
to save the settings.
11.1.7 View Network Status
Click Start

Settings

Network

Network Status to view the network status or click on
the tool bar at the bottom of the live preview interface to view network status conveniently.
11.2 Basic Configuration
11.2.1 Common Configuration
Click Start

Settings

System

Basic

General Settings to go to the following interface. Set
the device name, device No., language, video format, and resolution. Enable or disable wizard,
“Log In Automatically” and “Log Out Automatically” (if checked, you can set the wait time).
Click “Apply” to save the settings.