EN
Viper 70mm EDF
6
Model Assembly
(Continued)
PNP Receiver Selection and Installation
Wing Installation
1. Find the y-harnesses included in the accessory bag.
2. Connect the y-harness marked AILE to both aileron servos.
3. Connect the y-harness marked FLAP to both flap servos.
4. Connect the y-harness marked GEAR to both main gear retracts.
5. Feed the y-harness leads from the aileron and flap servos and the retracts
through the hole in the bottom of the fuselage as shown.
6. Slide the wing into place, ensuring not to pinch any of the servo wires.
7. Attach the wing to the fuselage with six 3 x 16 mm screws. Do not over
tighten the screws.
The recommended receiver for this aircraft is the Spektrum AR636A.
If you choose to install a different receiver, ensure that it is at least a 6-channel
full range (sport) receiver. Refer to the manual of your chosen receiver for correct
installation and operation instructions.
AR636A Installation
1. Slide the canopy latch back and lift the back of the canopy to remove the
canopy from the fuselage.
2. Attach the appropriate control surfaces to the their respective ports on the
receiver using the table at the right.
3. Using double-sided servo tape, mount the receiver as far back in the battery
compartment as possible. The receiver should be mounted parallel to the
length of the fuselage, with the label facing up and the servo ports facing the
rear of the aircraft, as shown. The orientation of the receiver is critical for all
AS3X
®
and SAFE
®
technology setups.
CAUTION:
Incorrect installation of the receiver could cause a crash.
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder/Nose Wheel
5 = Retracts
6 = Flaps