16
E-flite Fokker DVII 250 Slow Flyer Assembly Manual
3. Use foam-safe CA to glue the outer strut to the
top and bottom wing after checking the fit of the
strut. Allow the CA to fully cure before proceeding.
4. Repeat Steps 2 and 3 to install the remaining
outer strut.
Landing Gear Installation
Required Parts
Fuselage assembly
Landing gear
Wheel (2)
Wheel retainer (2) Double-sided tape
Required Tools and Adhesives
Hobby knife with #11 blade Foam-safe CA
Low-temp hot glue
1. Slide one of the wheels onto the landing gear.
The wheel should rotate freely on the gear. If not,
use a hobby knife and #11 blade to enlarge the
hole in the wheel slightly for free rotation.
2. Slide the wheel retainer onto the landing gear
wire. Use a drop of foam-safe CA on the side
away from the wheel to secure the retainer. Make
sure not to get CA on the wheel or axle, preventing
the wheel from rotating.
3. Install the remaining wheel and secure it
following the procedure described in Steps 1
and 2.
