Ventral Fin Installation
1. Insert the mounting tab into the mounting bracket.
IMPORTANT:
There is a left and right ventral fin. Refer to the illustration for
proper angle of the installed fins.
2. Slide the ventral fins to the rear to lock the tabs in place.
Disassemble in reverse order.
Wing Installation
1. Slide the short large diameter wing tube (10 x 420mm) (
A
) into the front hole
in the fuselage.
2. Slide the long, small diameter wing tube (7.75 x 750mm) (
B
) into the rear hole
in the fuselage.
3. Slide each wing on to the tubes until it fully mates with the fuselage, paying
close attention to make sure the hands free connector aligns and engages.
4. Secure the wing halves into position from the bottom using the four included
M3x20mm countersunk machine screws (2mm hex driver required).
Disassemble in reverse order.
EN
9
A
B
