14
Outrunner Motor Installation
Required Parts
Airframe
Brushless motor
Brushless speed control
Outrunner Mount (EFLM1915 - sold separately)
2mm x 8mm wood screw (2)
Required Tools and Adhesives
Phillips screwdriver (small)
Hobby knife
Hook & loop
Important Information about Your Brushless ESC
Make sure your ESC brake is programmed to Off. Also,
be sure to use an ESC with the proper 9V cutoff when
using 3-Cell Li-Po packs, or 6V cutoff when using 2-cell
Li-Po packs.
Note
: This section covers the installation of an
Outrunner. Skip back to Page 10 for Inrunner
Motor Installation.
1. Attach the outrunner stick mount (EFLM1915 - sold
separately) to the outrunner motor at this time. Use
the hardware provided with your motor to attach it
to the mount using at minimum of two screws.
Note:
It is also very important to check to be
sure the propeller is balanced before installing
onto the shaft.
2. When using the E-Flite™ outrunner motor and
mount, you will need to shorten the motor mount
stick by 13/16" (20mm). Use a razor saw to cut
the motor mount stick.
