5
EN
Installing the Flight Battery
1. Remove the battery hatch from the nose of
the aircraft.
2. Apply the included strip of hook and loop tape
in the center on the bottom of your battery.
3. For the recommended CG, install the battery
centered in the compartment, then press the
battery onto the hook and loop strip (
A
). See
the Adjusting the Center of Gravity instructions
for more information.
4. Connect a fully charged flight battery to the
ESC. See the Arming the ESC instructions for
correct connection of the battery to the ESC.
5. Reinstall the battery hatch.
CAUTION:
Always disconnect the Li-Po
battery from the ESC when not fl ying to eliminate
power supplied to the motor. The ESC does not have
an arming switch and will respond to any
transmitter input when a signal is present.
CAUTION:
Always disconnect the Li-Po
battery from the ESC when not fl ying to avoid
over-discharging the battery. Batteries discharged
to a voltage lower than the lowest approved voltage
may become damaged, resulting in loss of
performance and potential fi re when batteries
are charged.
A
