5
MANUAL CONTROLS
1. ON/OFF: The master switch must be on. Press the on/off button on the touchpad and the
flame effect will turn on. To turn the electric fireplace off, press the on/off button again.
(NOTE: the on/off button on the touchpad does not control the master power.
2. ACCENT LIGHTING: This allows you to create a mood and highlight the simulated brick
refractory inside your electric fireplace. Settings range between low, medium, high, and off.
3. FLAME EFFECT: Press the flame “+’ button to achieve the desired effect.
4. HEATING: Press the heat button once for low heat, and twice for higher heat to achieve the
desired temperature. (NOTE: the flame effect is always active when the heating cycle is
operating. Press the button a third time to turn the heat off.
GLASS INSTRUCTIONS
1. Under no circumstances should this product be operated with a broken or chipped glass
panel.
2. Do not strike or slam the glass.
3. Do not use abrasive cleaners to clean the glass. Make sure the glass is cool to the touch.
4. This product uses tempered glass. Replacement of the glass supplied by the manufacturer
should be done by qualified/authorized personnel only.
MAINTENANCE OF MOTORS
1. Always disconnect the unit from the main power supply and allow it to cool before any
servicing operation.
2.
The motors used on the fan heater and flame blower are pre-lubricated for extended bearing
life and require no further lubrication. However, periodic cleaning/vacuuming of the unit
around the air intake and exhaust, as well as the fan heater, is recommended. For heavy
blows alternating cold and warm air, check the fan for free movement and for debris
restricting air flow. If the fan does not move freely, the unit needs to be turned off and the fan
replaced in order to prevent further damage of the unit.
