E.F. Johnson 984X SERIES, Дополнение к руководству по обслуживанию

Страница: 38 / 86

OPERATION
2-30
April 1999
Part No. 001-9800-600
To mark a code as read, press the Select switch. A
beep then sounds and the next code is displayed if
applicable. Once all stored codes are marked as read,
they can no longer be displayed and “
CODE xx” is
not displayed at power up. However, they continue to
be stored and can be read using the programmer (see
next section).
2.14.2 READING ERROR CODES
The up to 11 error codes that can be stored can be
read out of the transceiver using the personality
programming software described in Section 3.
Connect the programming setup and then select File >
Read Codes or click the
icon in the toolbar (see
Section 3.5).
The screen shown in Figure 2-3 is then displayed
which indicates various information about each stored
error code. Contact the Customer Service Department
as described in Section 1 of your service manual for
additional information on the displayed error codes. To
permanently erase the current error codes from the
transceiver, click the “Clear
Codes” button at the
bottom of the screen.
*
*
Figure 2-3 Error Code Screen Displayed By Programmer