47
MISCELLANEOUS
SECTION 7 MISCELLANEOUS
7.1 SUPERVISORY TONES
Single Beep (Alert Tone)
•
Power was turned on and a successful power-up
sequence occurred (see “Turning Power On and
Setting Volume” on page 14).
•
The time-out timer is about to expire or the penalty
timer has expired (page 20).
•
The conversation timer is about to expire (page 28).
•
The system received your page but the paged mobile
is not on the air (page 42).
•
Telephone interconnect is not operational (page 41).
Continuous Tone (Invalid Condition)
•
A transmission is being attempted on a conventional
channel programmed as receive-only.
•
The transmitter is disabled by the transmit disable
on busy feature (page 27).
•
The transmitter has been disabled by the time-out
timer feature (page 20).
•
The transmitter has been disabled by the conversa-
tion timer (page 28).
•
An out-of-range condition exists (SMARTNET/
SmartZone only).
•
A transmission is being attempted before the penalty
timer has expired (page 20).
•
Dynamic regrouping has been exited but the
dynamic regrouping channel is still selected
(page 46).
Single Short Medium-Pitch Tone
•
A valid key has been pressed.
Single Short Low-Pitch Tone
•
An invalid key has been pressed.
Medium Tone (No Acknowledge)
•
The paged mobile did not acknowledge the page
(page 42).
•
The message that was sent has not been acknowl-
edged (page 43).
•
The status condition that was sent has not been
acknowledged (page 43).
Five Beeps (Recurring)
•
The page was received (page 42).
Two Short Tones
•
A unit-to-unit call was received (page 40).
Five Beeps
•
The paged mobile received the page and acknowl-
edged it (page 42).
•
The message that was sent has been received and
acknowledged (page 43).
•
The status condition that was sent has been received
and acknowledged (page 43).
Four Beeps
•
The emergency alarm condition was acknowledged
(page 44).
Gurgle-Like Tone
•
Dynamic regrouping has occurred (page 46).
•
Dynamic regrouping has occurred but the
regrouping channel is not selected (page 46).
Busy Signal
•
The radio system is busy or a busy condition exists
when making a telephone call.
Three Medium Pitch Tones
•
A channel is available after a busy condition
occurred (SMARTNET/SmartZone only).
7.2 SYSTEM OPERATOR PROGRAMMING
As noted several times in this manual, program-
ming determines the availability and specific operation
of many features. This usually refers to the program-
ming performed by your system operator when the
