PROGRAMMING
3-6
Revised July 1999
Part No. 001-7500-002
Parameter
Description
Scan
Programs if the channel is scanned (scan list status). Press (Enter) to display the selection screen or select the
desired condition by pressing the spacebar or backspace key. The scan list status of the currently selected chan-
nel is changed by pressing the Scan function key for 2 seconds. This capability can be inhibited and the default
scan list status of the channel programmed as follows:
Inh - The channel is not scanned and its scan list status cannot be changed by the Scan key.
Ena - The channel is not scanned and its scan list status can be changed by the Scan key.
Tag (Inh) - The channel is scanned and its scan list status cannot be changed by the Scan key.
Tag (Ena) - The channel is scanned and its scan list status can be changed by the Scan key.
Auto Reset If PWR ON Scan is enabled in the Scan screen (see Table 3-5), this selects the time delay before scanning
resumes after a call is complete (the signal disappears) or a key is pressed. Either Timer A or Timer B can be
selected. These timers are programmed in the Common 1 Screen (see Table 3-7). Auto reset can be turned off
by setting the timer to “Off” (0).
2-Tone Dec
(Decode)
Turns on 2-tone receive mute and specifies the 2-tone code used on the channel. The 2-tone codes are
programmed in the 2-Tone Code Ch screen (see Table 3-6). This requires the 2-tone option kit.
Log On/Off Specifies how the DTMF ID code is transmitted when the PTT switch is pressed and released. The DTMF code
is specified on the Log/ID line of the DTMF Autodial screen (Table 3-3). The following conditions can be pro-
grammed:
OFF (blank) - No ID code is transmitted.
Log In - The ID code is transmitted when the PTT switch is pressed.
Log Off - The ID code is transmitted when the PTT switch is released.
Both - The ID code is transmitted when the PTT switch is pressed and again when it is released.
NOTE: Additional DTMF information is programmed in the TOT ID out setting in the Common 1 screen.
Scrambler
On-Off/Code
This function should be left in the default condition because the particular scrambler it controls is not available
with this transceiver.
Table 3-2 Key and Display Assign Screen Description
KEY AND DISPLAY ASSIGN 1
With the standard (7-key) model, the
and F1-F4 keys can be programmed for the following functions. With the
DTMF keypad (24-key) model, the
,
, and F1-F4 keys can be programmed with any of these functions, and the A-D keys
can be programmed for all functions except DTMF Autodial and Emergency Repeat/Single.
Parameter
Description
Null
No function except it turns the backlight for 5 seconds if the Backlight parameter in screen 2 is set to “AUTO”.
Light
Turns the LCD backlight on and off. When turned on, the backlight stays on for 5 seconds or until the switch is
pressed again.
Table 3-1 Memory Channel Screen Description (LMR Models) (Continued)