RX LED and Key Function Description
Switch
Function
Description
POWER
RF switch RF on / off switch
Volume
control
Volume up / down pull
CONNECT
ID
Learning
Trigger
When simultaneously press the
buttons both on Tx and Rx module
longer than 3 seconds, the ID
learning process will be enabled.
LED Function
Description
LED3
ID /
Sync
1. When sync and audio playing LED on.
2. When No Sync or No audio input or
Low battery LED blinking by 1s on / 1s
off.
3. When ID learning LED blinking by
0.25s on/0.25s off, then keeping on
after learning success.
4. LED off after auto shut down.
Use Introduction
1)
Open RX battery cover
，
put in 2pcs 1.5V AAA batteries as
battery box polarity indication, then close it.
2)
Insert DC 5V power adapter into the USB slot of transmitter,
then “LED1” will blink slowly, and “LED2” will keep on
3)
Input audio signature into “USB/Audio” of transmitter
4)
Move the switch to be ”USB/Audio in” to make sure the
switch position match the audio input
5)
Press Power of Headset to be power on, then “LED3” will
blink slowly
6)
Press the “CONNECT” button of transmitter and headset at
the same time for 3 second, then “LED1” and “LED3”will
change to keep on from quick blink
7)
Adjust the Volume after connect successfully
8)
The end
。
Attention
1)
When put in battery, please set as battery box polarity indication, don’t
put in different class battery
2)
When no using, switch to the power switch to “OFF”, avoiding power
waste
a)
When warn of low voltage, please change battery immediately.
b)
No work for long time, please take out battery , avoid leaking
from battery to damage inner current.
c)
Don’t dismantle this products.
d)
The final explantation right for this manual belong to ECORE
TECHNOLOGY(CHINA) CO., LTD.