Date Februar 2018
Akku Vision - Manual PowerPack for Bosch* Classic
S.
8
/
9
Version 05
*Bosch is a trademark of the Robert Bosch GmbH
Break up of charging process
•
To complete the charging, switch off the charger and unplug the charging plug of the battery. Reattach the
cap of the charging socket and pull the power plug of the charger from the wall socket.
•
If you charged your battery within your eBike, so please turn off and on your drive system, so that it can
calculate the range.
Charging with your original charger is completed, as soon as all LEDs are lighting permanently.
With the E-Bike Vision fast charger, charging is completed, as soon as all LEDs of the battery are lighting and
charger LED is lighting solid green or red.
If the charger’s LED lights red, this is no cause for concerns. This can signalise for example, that the battery
management system has finished charging for balancing the individual cell voltages of the installed cells. This
ensures the lifetime and the safety of your battery.
Charging time
The battery with a capacity of 13 Ah requires about 4 hours to be fully charged with the standard charger and about
2 hours with our fast charger.
The battery with a capacity of 17 Ah requires about 5 hours to be fully charged with the standard charger and about
3 hours with our fast charger.
Of course, you can continue to use your old charger. Please proceed as described within the manufacturer’s
manual.
ATTENTION: Charge your PowerPack always with minimum 4A charge current (that is called the so called rapid
charging)!
If you own the first generation charger (metallic housing), please make sure that you charge in the rapid charge
mode (indicated by the flashing charger LED).
Battery usage
Please consider the safety instruction given earlier during usage of your E-Bike Vision PowerPack.
Your PowerPack will enter automatically into sleep-mode (if it is not installed in the eBike) after 3 seconds to
prevent itself of self-discharging. Also, it will shut down the drive system after 10 minutes of no use of the eBike.
It is irrelevant whether the lights are enabled or not!
Take care, that the battery is in its correct position, before inserting. If not, you can damage the battery’s housing.
Before each use of PowerPack, it must be activated by pushing the capacity indicator button or by pushing the
ON / OFF switch of the HMI.
Do not press the capacity indicator button several times in quick succession, this activates and deactivates the
battery once again.
You installed your new E-Bike Vision PowerPack correctly in your eBike and locked it (do not forget to remove the
key)? Then turn on the drive system by the capacity indication button or via the ON /OFF switch of your HMI. The
drive system now read the current capacity of the battery and will calculate the approximated range, based on your
previous driving profile. The drive system is ready for use as soon as the speed is displayed.
