14
5. Operating
Placing Bills onto the Hopper
It is very important to place the bills onto the hopper correctly because recognition performance of
the bills is highly affected by the arrangement of the bills. Please avoid counting bills in bad
condition such as wet, excessively dirty, spoiled, folded, curled notes and with foreign material like
clips, bands, etc. Sometimes it causes malfunction of the machine.
Counting
If ADD mode was set, the cumulative number will be displayed.
If an error occurs during operation and the machine stops, then an error message will be displayed.
To clear the error, press RESET / START key. The machine will try to solve the problem
automatically, but if it fails to clear a jam or there are some other mechanical errors, remove
jammed bills manually. Then press the start/stop key again to clear error message.
Selecting Add Function
ADD
function provides a cumulative count, to the operator. For example, if someone tries to count
up to 400, but the machine cannot count over 300, which is maximum capacity of the Stacker.
But pressing
ADD
key, then try to count again. The machine counts and stops when the stacker is
full. After removing those notes from the Stacker, you can begin counting again, and the total
counted number will be increased from the previous total.
The Add function is On/Off by pressing ADD key and clears counted value by RESET / START key.
Selecting Batch Function
BAT
key is used to select preset batch number. In the batch count mode, the machine stops
counting when the counted number reaches at the set number, even though the bills remain on the
Hopper. User can edit batch number by pressing 0~9 number key.
Selecting Automatic/Manual
In AUTOMACTIC mode, when the hopper sensor detect banknote on the hopper, machine will
automatically start to count the bill.
In MANUAL mode, the machine will not count the bills automatically even though the bills are onto
the hopper. When user presses RESET / START key manually, the machine will start to count.
While counting, the machine will display the number of the bills on FND display and it stops
working when it meets the conditions described as below;
-
No bills on the hopper
-
The number of the bills counted is the same as the batch number to be set in BATCH mode.
-
Errors have occurred.
When the machine finishes counting without errors, the number of counted bills will be displayed on
the screen.
