9. Programming
Note:
Before you start programming, make sure that there are no objects in the movement
area of the door.
9.1 Programming the remote controls (some optional accessories)
Note:
The radio transmitters provided are generally factory pre-programmed. The following
instructions apply for the remote controls, which are not included with delivery and are
purchased additionally as well as to reprogram the transmitter included with delivery.
Step 1:
Press and hold the button "P" until LED 7 flashes.
Step 2:
Press the button "+", all LED's are off, except LED 7.
8. Deactivate the automatic closing function of the door drive (about 5 minutes)
Note:
before starting work these instructions must be read completely and the safety
instructions of the manual of the drive must be follow! Keep the instruction of the door drive
necessarily and directly at hand.
Note: Changes to the settings are only possible from the control panel to the drive (see the
figure below).
1) Press button "P" - all LEDs light up, LED 2 flashes
2) Press button "P" - all LEDs light up, LED 4 flashes
3) Press button "P" - all LEDs light up, LED 6 flashes
4) Press button "P" - all LEDs light up, LED 1 flashes
5) Press button "P" - all LEDs light up, LED 8 flashes
6) Press button "-" (minus) - all LEDs are off, except LED 8
7) Press button "P" to save - all LEDs are off, except LED 3 light up
Now the automatic closing function is deactivated.
Attention!
After completion of work, all the drive settings must be checked. The settings for opening and closing
the door to be corrected if necessary. The corrections of the settings are adjust according to the
safety instructions in the manual of the door drive!
29
