Emptying your bin
Empty your bin as soon as the dirt reaches the MAX mark.
You may need to clean the filter more often if you use your machine with a full bin.
Cleaning your bin
Release the dirt
To remove the bin for emptying:
Minimise dust contact
Reassemble your machine
Don’t put any part of your machine in a dishwasher or use detergents,
polishes or air fresheners.
Hold your vacuum over a bin.
Push the red bin release button, taking care not to press the power button.
The bottom of the bin will open and the shroud will slide down inside the bin,
wiping away any dirt.
If the bin doesn’t open, check the bin release button is pushed down fully.
If the bin doesn't empty fully, remove the bin and empty the dirt.
Press the red button located on the bin runner to release the bin and slide
your bin off the runner.
Cover your bin tightly in a dust proof bag while you empty. Remove the bin
carefully, seal the bag tightly and dispose.
If you have removed your bin, slide it back on to the runner. Make sure that
the bin and lid are both securely in position.
Push the bin base upwards until the bin and lid both click into place.
Reconnect the wand.
2
1
2
1
1
clik
clik
2
Replace your bin
Clean your bin
If it is necessary to clean your bin, empty it as shown in the ‘Emptying your
bin’ section.
Press the red button located on the bin runner to release the bin and slide
your bin off the runner.
Only clean your bin with a damp cloth.
Make sure that the bin and seals are completely dry before replacing.
Insert the spine on to the bin runner.
Close your bin by pushing the bin base upwards until the bin and bin base
click into place.
The MAX mark on the bin of the
machine, showing that the dirt
should not be filled over the Max
mark when the machine is at the
angle of normal use.
Illustration of
the bin being
emptied into
a bag.
Two images of the bin with arrows
showing the bin lid closing and
a click symbol and the bin being
pushed upwards with another
click symbol.
The bin lid
closing with an
audible click and
the bin being
pushed upwards
with another
click once it is
fully in place.
The bin being
removed and the
location of the bin
release lever on the
underside of the
bin runner.
The bin being pushed
back into position on
the bin runner.
