13
DX-DRTVL103
Need help? Call 800-305-2204
Step 6:
Mount the wall plate (continued)
Note:
Any material covering the wall (such as sheetrock) must not exceed 5/8" (16 mm).
Option 2: Mounting on a solid concrete or concrete block wall
1
Level the wall plate (
01
) and mark the hole locations.
2
Drill pilot holes to a depth of 3" (75 mm) using a 3/8 in. (10 mm) diameter masonry drill bit.
3
Insert concrete wall anchors (
06
) into the pilot holes and make sure that the anchors are seated flush with the
concrete surface.
4
Align the wall plate with the anchors. Place washers (
05
) over the screw holes in the wall plate, insert
lag bolts (
04
) through the washers, then tighten the lag bolts only until the washers are pulled firmly against the
wall plate.
Warning:
Avoid potential injuries or property damage. DO NOT over-tighten the lag bolts (
04
).
You’ll need:
01
06
06
01
06
04
05
Never drill into
the mortar
between blocks.
< 5/8"
(16 mm)
3" (75 mm)
05
(4)
04
(4)
Pencil
Drill
Socket wrench with
1/2" (13 mm) socket
or adjustable wrench
3/8" (10 mm)
masonry drill
bit
Level
Hammer
06
(4)
DX-DRTVL103_12-0662_MAN_V3_English.fm Page 13 Tuesday, June 19, 2012 12:32 PM