Dyness PowerDepot H5B, Руководство пользователя

Страница: 5 / 33

PowerDepot H5B series User Manual
III
Safety Precautions and maintenance instructions
Warning

Please do not put the battery into water or fire, in case of explosion or any other situation
that might endanger your life.

Please connect wires properly while installation, do not reverse connect.

To avoid short circuit, please do not connect positive and negative poles with conductor on
the same device.

Please avoid any form of damage to battery, especially stab, hit, trample or strike.

Please shut off the power completely when removing the device or reconnecting wires
during the daily use or it could cause the danger of electric shock.

Please use dry powder extinguisher to put out the flame when encountering a fire hazard,
liquid extinguisher could result in the risk of explosion.
 For your safety, please do not arbitrarily dismantle any component in any circumstances.
The maintenance must be implemented by authorized technical personnel or our company’s
technical support. Device breakdown due to unauthorized operation will not be covered
under warranty.
Caution

Our products have been strictly inspected before shipment. Please contact us if you find any
abnormal phenomena such as device outer case bulging.

The product shall be grounded properly before use in order to ensure your safety.

To assure the proper use please make sure parameters among the relevant device are
compatible and matched.

Please do not mixed-use batteries from different manufacturers, different types and models,
as well as old and new together.

Ambient and storage method could impact the product life span, please comply with the
operation environment instruction to ensure device works in proper condition.

For long-term storage, the battery should be recharged once every 6 months, and the
amount of electric charge shall exceed 80% of the rated capacity.

Please charge the battery in 18 hours after it fully discharged or over-discharging protection
mode is activated.

Formula of theoretical standby time: T=C/I (T is standby time, C is battery capacity, I is total
current of all loads).

The surface of the PowerDepot cabinet is affixed with a torn invalid label. Therefore, before
opening the cover to change the DIP switch mode, you need to contact DYNESS and inform
the product ID. DYNESS will record this battery ID and authorize the opening operation to be
performed. Except for changing the DIP switch mode, no other operations are allowed. In
the next stage, you can log in to apply for operations directly on the DYNESS website.
Contact the authorized dealer or distributor of DYNESS for a new torn invalid sticker after
tearing the original invalid label. When the operation is completed, paste the new one at a
different position.