4
Low output MC - standard phono
The diagram below shows the available settings for using the P75 in
standard amplifier mode with low output moving coil cartridges.
Not sure what setting to use?
The cartridge manufacturer usually recommends loading settings.
If no cartridge information is available, we strongly recommend the default
setting of: 100 Ohm, 63dB gain. (As per the jumper position shown below).
One channel shown, other channel is identical
Medium output - 1mV MC
Use "Low output MC - standard phono" mode above.
Set gain to 56dB by fitting all three jumpers to JB3 & JB4.
Set loading to 470 Ω via JB1 & JB2.
See above for jumper locations.
nnel is identical
Additional input
capacitance can be added
via JB11 and JB12.
For MC cartridges this is
not required and will have
little effect.
Set gain via JB3 and JB4
Adjust loading resistance via JB1 and JB2
Fit custom Resistor and Capacitor loading here
(remove normal loading jumpers from JB1 and JB2)
