1
IMPORTANT SAFETY INSTRUCTIONS
Read and keep Instructions:
Please read all safety and operating instructions
before using this product and retain them for future reference.
Heed warnings:
All warnings on the product and in the operating instructions should
be adhered to.
Follow instructions:
All operating and use instructions should be followed.
Cleaning:
Unplug the product from the wall outlet before cleaning. Do not use liquid
or aerosol cleaners. Use a damp cloth for cleaning.
Power sources:
This product should be operated only from the type of power source
indicated on the marking label. If you are not sure consult your dealer.
Servicing:
Refer all servicing to qualified service personnel.
Warranty:
Dynavector products are manufactured to very high standards. The Dynavector P75
has a one year warranty to the original owner, from the original date of purchase,
against defects in material and workmanship This warranty does not extend to
damage caused by improper use/installation, faulty ancillary equipment, modifications,
unauthorised repair, shipping damage or loss, abuse, accidents, use on improper
voltage/current, lightning or other acts of God, normal wear and tear, commercial use,
or purchases from unauthorised dealers. Proof of purchase as evidence the unit was
purchased from an authorised dealer within the warranty period may be required for
warranty service. Do not return the product without first contacting your dealer or
Dynavector distributor. This warranty is nontransferable.
P75 mk4 Power Supply and Grounding Notes
The P75 mk4 introduces a new ultralow noise power supply that is electrically
isolated from the input power. It takes the low grade single voltage DC supply from
the AC adaptor and converts it to dual high voltages required for true professional
quality audio reproduction. Power supply noise is virtually unmeasurable.
The P75 does not have any mains frequency or other low frequency components in
the power supply and so hum problems that plague conventional phono amplifiers are
eliminated.
While the P75 itself does not generate any hum, the tone arm and interconnect cables
may act as antennae and pick up hum. To remove hum, connect an earth wire from
the turntable to a ground point, usually the preamp/integrated amp ground.
The P75 is not earthed. An earth terminal is provided on the rear panel that will allow
the P75 to be connected to a ground point if required.
