20
Dynaudio
Connecting the power cable and adjusting
1.
In stereo mode:
– Select
Left
operating mode for the left speaker.
– Select
Right
operating mode for the right speaker.
– Select
Mono
for mono operating mode.
2.
Set the speaker position switch that best describes the speakers need for acoustic compensation.
–
Neutral
= with free-standing placement
–
Wall
= if placed near a wall
–
Corner
= if placed in a corner
3.
Select the
Red
,
Green
, or
Blue
zone. In stereo, select the same zone for the right and left
speakers. Speakers with different zone settings can be controlled separately via the remote control
(see „Division into audio zones“ on page 26 for further information).
4.
Use the power cable to connect the speaker to the mains voltage.
Power it on using the power switch on the rear.
Switching on
To switch the speaker on from standby mode:
► Press
on the interface display or press
on the remote control.
▼
The speaker will automatically search for an active Hub and an audio signal. If found, the signal
will be output (autoplay function).
▼
If there is no input signal, the speaker will keep on scanning the inputs for the next 20 minutes
and go to sleep mode.
If there is no input signal, the speaker will go into standby mode after a certain period.
Selecting a Hub or input/autoplay function
After it is turned on, the speaker automatically searches for an audio signal and then plays it back
immediately. If several signal sources are active, one of the signal sources will be played back. Select
a different Hub or input if you want to play back a different signal source.
To select a different Hub or input:
► Press HUB
A
,
B
, or
C
or INPUT
1
,
2, 3
, or
4
on the remote control.
▼
The selected signal source will be played back.
Содержание Xeo 4
Страница 1: ...Owner s Manual Xeo 4 Xeo 6 English ...