Dynaudio Xeo 10/20/30
19
18
Fixing the volume
Fixing the
volume
You can set the speaker to a higher volume using the function to fix the volume. This
setting also remains in effect in standby mode. If a signal source is connected to the
Xeo 10/20/30 with its own volume control, you have the option to change the output
volume across a broad range with the signal source.
To fix the volume:
►
Point the remote control at a speaker and press
for at least 2 seconds. To undo
fixing, press one of the two volume buttons.
Standby
To switch speakers to sleep mode:
►
Point the remote control at a speaker and press
or press on top of one of the
speakers.
– The speakers will enter sleep mode.
– The speakers also enter sleep mode if there is no audio signal for 20 minutes.
– In this mode, the wireless network is active and all connected units remain
synchronized.
– Sleep mode power consumption is <2 W.
To switch speakers to low-power standby mode:
►
Press and hold on the remote control for at least 5 seconds.
– The speakers go to low-power standby mode.
– In this mode, the wireless network is disabled and the speakers are not connected
to each other.
– Low-power standby mode power consumption is <0.5 W.
To turn off auto standby:
►
Press and hold
Opt
on the remote control for at least 5 seconds.
Status LEDs on the front
The two LEDs in the upper left corner of the cabinet front indicate the operational state
of the speakers and system with various colours and blinking functions.
LED blinking code
On-state
Illuminated in blue
The speaker is switched on, connected to a Hub or Connect, and an
audio signal is played back.
On-state
Slow blinking in blue
The speaker is switched on, connected to a Hub or Connect, but an
audio signal cannot be found.
On-state
Illuminated in purple
The speaker is switched on, connected to a local input, and an audio
signal is played back.
On-state
Slow blinking in purple
The speaker is switched on, connected to a local input, but an audio
signal cannot be found.
Connection
Slow blinking in red
There is no active transmitter
2)
/master or no connection possible.
Search
Fast blinking in blue for 20 min
Searching for an active input.
Synchronization/
Connection
Fast blinking in red for 10 s
System synchronization during no transmitter
2)
/master connection.
Blue LED is turned off for 0.2 s
New transmitter
2)
ID, transmitter
2)
input, or direct input is selected.
Illuminated in red for 5 s
Receiver mode is changing.
Illuminated in white
Bluetooth connection is established.
Slow blinking in white
Speaker is in pairing mode.
Firmware loading
White LED: slow to fast blinking
during the load sequence,
Red LED: illuminated
Firmware is being loaded.
Volume
Fast blinking in blue
Volume is being adjusted.
Mute
Fading in and out
Speaker is muted.
Off-state
Illuminated dimly in red
Speaker is in standby mode.
1)
depending on the resolution of the audio source,
2)
Hub, Connect, mobile device, etc.
off
Illuminated in
white
Illuminated in
a colour
Slow blinking
(1 or 2 Hz)
Fast blinking
(3 or 4 Hz)
