Dynatron Dynatronics ibox, Руководство оператора

Страница: 18 / 35

18 Dynatron® ibox™ Operator’s Manual
|
Rev. 2
|
5/14/2019 Dynatron® ibox™ Operating Instructions
table of contents symbols & labels limited warranty prev
< >
next prev topic
< < >>
next topic
intensity level of 4.0 mA. The negative dose will take five more
minutes to administer (5:00 under time in the display window).
At the completion of the negative current delivery of a dual phase
treatment, the intensity (current) will be automatically “ramped-down”
by the device to 0 mA over a period of about ten seconds. At this
time, the device will generate four beeps followed by two beeps
(•••• ••) to signal the end of the treatment.
15.
Storing treatment parameters as Default Treatments
At the completion of a treatment, the user has the option of storing
the treatment parameters in the memory of the device’s microcontrol-
ler for use as “Default Treatments” in the future. This allows the user
to recall and start a commonly used treatment on a channel without
having to enter the treatment parameters.
To store a channel’s default treatment, the
user must wait for a treatment to complete.
The user then presses the up arrow key.
The display below will be seen by the user.
If the user presses the up arrow key, the
treatment parameters for the last treatment
(polarity/mode and dose) will be saved as
the default treatment. A single beep will be heard indicating storage
of the default treatment. The parameters for the previous default
treatment will be overwritten by the new parameters. Alternatively, if
you do not want to save the new default treatment parameters, press
the down arrow key to abort the save process. Treatment intensity
(current) levels are not stored as part of default treatment parameters.
Storing Default
Parameters