38
Dynaset Oy | Menotie 3, 33470 Ylöjärvi | puh. 03 3488 200 | [email protected] | www.dynaset.com
HYDRAULIC ROTARY VANE COMPRESSORS
OPERATION
5.2. STARTING THE COMPRESSOR
ATTENTION!
When starting the compressor, ensure that the unit is decompressed.
When the engine of base machine is running and hydraulic flow is available, the
HKL compressor can be started by opening the hydraulic control valve.
Picture 29: Starting the compressor
Compressor starts to produce usable compressed air when hydraulic flow achieves
the functional minimum rate, which is approx. a half of the nominal value.
The nominal discharge is achieved when the compressor is rotated by hydraulic
flow adequate to the nominal rotation speed.
NOTE!
Before using the compressor in cold conditions READ CHAPTER ”5.5. Cold
ATTENTION !
Compressor’s maximum pressure must not be exceeded in any
circumstances.
Hydraulic flow and pressure rates marked on the compressor’s type plate are
maximum and should not be exceeded in any circumstances. Exceeding the
maximum hydraulic flow causes compressor’s overspeeding and may damage it.
READ CHAPTER “10. TECHNICAL SPECIFICATIONS” for correct pressure and flow
rates.
Содержание HKL 1300
Страница 2: ......
Страница 73: ...DYNASET OY all rights reserved...