DYNAPAR NorthStar Rim Tach RT8500, Инструкция по эксплуатации

Страница: 13 / 24

NorthStar RIM Tach
®
8500 & 8500 Quad Instruction Manual
13 Dynapar (800) 873-8731 November 2008
Pulse Wheel and Enclosure Installation
Caution must be used when handling the pulse wheel assembly. The surface of the pulse wheel outer rim is
sensitive to scratches and impacts. The magnetic properties of the pulse wheel material can also be distorted or erased by
exposure to strong magnetic fields.
Remove pulse wheel assembly from packaging.
Push the pulse wheel along the motor shaft until there is approximately a one inch gap between the inner
face of the pulse wheel and the motor face.
Push the wire ring along the shaft until it is seated into the pulse wheel’s chamfer.
Push the clamping plate along the shaft until it is flush against the wire ring.
Align the clearance holes in the clamping plate with the threaded holes of the pulse wheel.
Insert screws and tighten, to snug, by hand.
Figure 6: Installation of RIMTACH 8500 with Clamp Ring Style Wheel
Please note Figure 6 shows sensor module mounted to enclosure. Sensor Module is the last step in the
installation process. Do not install enclosure with module in place!
Do not damage the pulse wheel when mounting the enclosure. If the pulse wheel
assembly is not far enough down the shaft, continue pushing it on with the enclosure until the
enclosure seats.
Wire Ring
Pulse Wheel
Pressure Plate
Enclosure