Dynapac SD2500W, Руководство по эксплуатации и техническому обслуживанию

Страница: 306 / 452

E 13 22
A
Before mounting the auger brace, the required auger height should already have
been set on the basic auger!
Note the section "Height adjustment for large operating widths / with brace"!
- Mount the left/right guide plates (1) on the vehicle frame shackles with the relevant
assembly parts (2).
A
The guide plates must be mounted on the front side of the shackles.
- Slide the support shackle (3) over the guide plate and secure in the groove with a
pin (4) and split pin (5).
- Slide the lower support shackle (3) over the attaching point of the material shaft and
secure with a pin (6) and split pin (7).
A
The brace bracket (8) is secured to the central panel of the machine using the corre-
sponding assembly parts.
- Insert the fulcrum bracket (10) into the brace bracket (8) and secure with the retain-
ing pin (11).
- Secure the retaining pins (11) with a split pin (12).
- Mount the slewing bracket (14) at the brace shaft (13) with retaining pins (15).
- Secure the retaining pins (15) with a split pin (16).
- Mount the braces (17) on the fulcrum bracket (10) with the assembly parts (18).
A
The braces must be mounted on the outer side of the fulcrum bracket (10)!
- Remove the spring cotter pin (19) and retaining pin (20), pull out the adjustment rod
(21) until the brace can be mounted on the slewing bracket (14) together with the
corresponding assembly parts (22).
- Secure the adjustment rod (21) in an appropriate bore with a retaining pin (20) and
spring cotter pin (19).
- Mount the vertical brace (23) in the same way.
- In this case, secure the vertical brace at the outer auger bearing (24) and the low-
er support bore (25).
A
At the support (3) mounting point, the brace must be secured at the rear side in each
case!