Dynapac F2500C, Руководство по эксплуатации и техническому обслуживанию

Страница: 230 / 410

E 10 2
2 Distribution auger
2.1 Height adjustment
Depending on the mix of materials, the
set height of the distribution auger (1) –
measured from its bottom edge – should
lie above the material layer height.
Grain sizes up to 16 mm
Example:
Paving thickness 10 cm
Min. height setting 15 cm
from the ground
Grain sizes > 16 mm
Example:
Paving thickness 10 cm
Min. height setting 18 cm
from the ground
A
An incorrect height setting can result in the following problems during paving:
- Auger too high:
Too much material in front of the screed; material overflow. When operating with
larger working widths, demixing and traction problems may occur.
- Auger too low:
Not enough material that can be precompacted by the auger. Irregularities resulting
from this cannot be completely compensated by the screed (wavy surface).
In addition, increased auger segment wear occurs.
F0130_A1.TIF
1