Dynapac CA 262 Series, Руководство по обслуживанию

Страница: 23 / 40

21 CA 262/362/512 M262EN2
EVERY 250 HOURS OF OPERATION (Monthly)
Place the roller on a level surface. Switch
the engine off and push in the reserve/
parking brake knob for all checking and
adjustments on the roller, unless otherwise
specified.
Check that air can flow freely through the radiators (1),
(2) and (3).
A dirty radiator should be blown clean with compressed
air, or alternatively cleaned with a high-pressure washer.
Blow or wash the cooler in the opposite direction to that
of the cooling air.
Be careful when using a high-pressure washer
– do not place the nozzle too close to the
radiator.
Use protective goggles when working with
compressed air or a high-pressure washer.
Fig. 30 Engine room
1. Water cooler
2. Intercooler
3. Hydraulic fluid cooler
Radiator
– Check/clean
1 2
3
Fig. 29 Drum
1. Ventilated screw
Drum cartridge
– Cleaning the ventilation screw
Clean the drum ventilation hole. The hole is required to
eliminate excess pressure inside the drum.
1
Then unscrew the level plug (3) at the bottom of the
cartridge until the hole in the middle of the plug
becomes visible.
Top off with oil through the filling plug (1), until oil begins
to run out from the level-plug hole. The level is correct
when it stops running.
Ensure that only MOBIL SHC 629 is used in
the cartridges.
Clean and refit the plugs. Repeat the procedure on the
opposite side.
Do not overfill with oil – risk for overheating.
Drum cartridge
Fig. 28 Drum cartridge
2. Drain plug
3. Level plug
3
2