Dynamite PROPHET SPORT, Инструкция по эксплуатации, Страница: 3 / 6

4 5
fEaTuRES
2
3
4
1
1. 110V AC power cord
2. 12V DC power cord with alligator clips
3. Charge rates of 1, 2, or 4 amps
4. LED and beeper indicate when charge
is complete
5. Tamiya-style connector
Additional Features
• Receiver pack charge lead adapter included
• Charges 4- to 8-cell Ni-Cd or Ni-MH battery packs
• Limited 5-year warranty
• Advanced trickle charge
• Advanced peak detection circuitry
• Ni-Cd and Ni-MH compatible
CAUTION: Attempting to charge batteries different than those specified in this manual can result
in excessive heat and other related product malfunctions, which can lead to user injury
or property damage. Please contact Horizon Hobby or an authorized retailer with
compatibility questions.
SupplyINg pOWER TO ThE ChaRgER
This charger can be powered by connecting it to a 12V DC power source, such as a 12V sealed battery
(HAN102) or an automobile battery.
CAUTION:
If you choose to power your charger with an automobile battery, never do so with the auto-
mobile running as fluctuation in power can cause product malfunction and possibly injury.
CAUTION: Never connect the AC and DC input cords to an active power source at the same time. This
will void the warranty, cause product damage and possibly injure the user.
AC Power
To power the Vision Peak 2 AC Charger, connect the AC power cord into a standard 110V wall outlet.
NOTICE: Always consult 12V battery collateral materials or Horizon Hobby before using with sources
other than standard AC wall outlet.
DC Power
If you power the charger by using DC power, connect the red (positive) end of the alligator clips to the red
terminal of the DC power source and the black (negative) end of the alligator clips to the black terminal of
the DC power source.
WARNING: Always make sure that you follow proper polarities at all times or electrical shock will occur.
Charging 6- & 8-Cell Ni-Cd or Ni-MH Battery Packs
1. When power is supplied to the charger, the charger will beep, and the LED will flash once.
2. Connect the battery pack to the charger, and the charger will beep again. The LED will repeatedly
blink until you begin the charging process.
Note: For optimum performance, charge 6- to 8-cell packs using a DC power source. With AC power, the
charger can only supply up to 2 amps of charge current.
3. Select the charge rate based on the batteries capacity rating. See “Charge Times” chart on the back
page.
4. Push the Start button to begin the charging process. The LED will be solid red during the charging
process.
5. Once the battery has peaked, the LED will flash, and the beeper will sound for 30 seconds. If the
battery is left connected after 30 seconds, the LED will continue to flash, and the beeper will sound
approximately every 90 seconds.
When the battery has peaked, the Prophet Sport will automatically transition to Advanced Trickle Charge.
Charging 4- & 8-Cell Ni-Cd or Ni-MH Radio Packs
1. When power is supplied to the charger, the charger will beep, and the LED will flash once.
2. Connect the battery pack to the charger using the included receiver charge adapter, and the charger
will beep again. The LED will repeatedly blink until you begin the charging process.
3. Select a charger rate of either 1 or 2 amps, depending on the receiver pack you are going to charge.
We recommend you charge 600mAh or lower capacity receiver pack at 1 amp, while you may charge
higher capacity packs at 2 amps.
4. Push the Start button to begin the charging process. The LED will be solid red during the
charging process.